3.5.3 Actions

An action accompanies a syntactic rule and contains C code to be executed each time an instance of that rule is recognized. The task of most actions is to compute a semantic value for the grouping built by the rule from the semantic values associated with tokens or smaller groupings.

An action consists of braced code containing C statements, and can be placed at any position in the rule; it is executed at that position. Most rules have just one action at the end of the rule, following all the components. Actions in the middle of a rule are tricky and used only for special purposes (see section Actions in Mid-Rule).

The C code in an action can refer to the semantic values of the components matched by the rule with the construct $n, which stands for the value of the nth component. The semantic value for the grouping being constructed is $$. Bison translates both of these constructs into expressions of the appropriate type when it copies the actions into the parser file. $$ is translated to a modifiable lvalue, so it can be assigned to.

Here is a typical example:

exp:    …
        | exp '+' exp
            { $$ = $1 + $3; }

This rule constructs an exp from two smaller exp groupings connected by a plus-sign token. In the action, $1 and $3 refer to the semantic values of the two component exp groupings, which are the first and third symbols on the right hand side of the rule. The sum is stored into $$ so that it becomes the semantic value of the addition-expression just recognized by the rule. If there were a useful semantic value associated with the ‘+’ token, it could be referred to as $2.

Note that the vertical-bar character ‘|’ is really a rule separator, and actions are attached to a single rule. This is a difference with tools like Flex, for which ‘|’ stands for either “or”, or “the same action as that of the next rule”. In the following example, the action is triggered only when ‘b’ is found:

a-or-b: 'a'|'b'   { a_or_b_found = 1; };

If you don't specify an action for a rule, Bison supplies a default: $$ = $1. Thus, the value of the first symbol in the rule becomes the value of the whole rule. Of course, the default action is valid only if the two data types match. There is no meaningful default action for an empty rule; every empty rule must have an explicit action unless the rule's value does not matter.

$n with n zero or negative is allowed for reference to tokens and groupings on the stack before those that match the current rule. This is a very risky practice, and to use it reliably you must be certain of the context in which the rule is applied. Here is a case in which you can use this reliably:

foo:      expr bar '+' expr  { … }
        | expr bar '-' expr  { … }
        ;

bar:      /* empty */
        { previous_expr = $0; }
        ;

As long as bar is used only in the fashion shown here, $0 always refers to the expr which precedes bar in the definition of foo.

It is also possible to access the semantic value of the lookahead token, if any, from a semantic action. This semantic value is stored in yylval. See section Special Features for Use in Actions.