File: coreutils.info,  Node: Special,  Prev: Characters,  Up: stty invocation

19.2.7 Special settings
-----------------------

‘min N’
     Set the minimum number of characters that will satisfy a read until
     the time value has expired, when ‘-icanon’ is set.

‘time N’
     Set the number of tenths of a second before reads time out if the
     minimum number of characters have not been read, when ‘-icanon’ is
     set.

‘ispeed N’
     Set the input speed to N.

‘ospeed N’
     Set the output speed to N.

‘rows N’
     Tell the tty kernel driver that the terminal has N rows.
     Non-POSIX.

‘cols N’
‘columns N’
     Tell the kernel that the terminal has N columns.  Non-POSIX.

‘drain’
     Apply settings after first waiting for pending output to be
     transmitted.  This is enabled by default for GNU ‘stty’.  Note this
     is treated as an option rather than a line setting, and will follow
     the option processing rules described in the summary above.  It is
     useful to disable this option in cases where the system may be in a
     state where serial transmission is not possible.  For example, if
     the system has received the ‘DC3’ character with ‘ixon’ (software
     flow control) enabled, then ‘stty’ would block without ‘-drain’
     being specified.  May be negated.  Non-POSIX.

‘size’
     Print the number of rows and columns that the kernel thinks the
     terminal has.  (Systems that don’t support rows and columns in the
     kernel typically use the environment variables ‘LINES’ and
     ‘COLUMNS’ instead; however, GNU ‘stty’ does not know anything about
     them.)  Non-POSIX.

‘line N’
     Use line discipline N.  Non-POSIX.

‘speed’
     Print the terminal speed.

‘N’
     Set the input and output speeds to N.  N can be one of: 0 50 75 110
     134 134.5 150 200 300 600 1200 1800 2400 4800 9600 19200 38400
     ‘exta’ ‘extb’.  ‘exta’ is the same as 19200; ‘extb’ is the same as
     38400.  Many systems, including GNU/Linux, support higher speeds.
     The ‘stty’ command includes support for speeds of 57600, 115200,
     230400, 460800, 500000, 576000, 921600, 1000000, 1152000, 1500000,
     2000000, 2500000, 3000000, 3500000, or 4000000 where the system
     supports these.  0 hangs up the line if ‘-clocal’ is set.