[ < ] | [ > ] | [ << ] | [ Up ] | [ >> ] | [Top] | [Contents] | [Index] | [ ? ] |
3.24.35 logscale
Syntax:
set logscale <axes> <base> unset logscale <axes> show logscale |
where <axes> may be any combinations of ‘x‘, ‘x2‘, ‘y‘, ‘y2‘, ‘z‘, and ‘cb‘ in any order, and where <base> is the base of the log scaling. If <base> is not given, then 10 is assumed. If <axes> is not given, then all axes are assumed. The command logscale turns off log scaling for the specified axes.
Examples:
To enable log scaling in both x and z axes:
set logscale xz |
To enable scaling log base 2 of the y axis:
set logscale y 2 |
To enable z and color log axes for a pm3d plot:
set logscale zcb |
To disable z axis log scaling:
unset logscale z |